Lead Pipe Replacement in Wells

What the work involves

• A survey to confirm the pipe material and trace its route
• A new MDPE supply pipe laid from the boundary to your internal stop tap
• Trenchless installation (impact moling) where ground conditions allow
• Connection, pressure testing and reinstatement of any excavated areas

When you need it

• Your water has a metallic taste or you've had a lead test result
• The property pre-dates 1970 and still has its original supply
• You're renovating and want the supply brought up to modern standards
• Your water company has flagged lead on your side of the boundary

Is your pipe lead? A two-minute check

Find the pipe at the internal stop tap, usually under the kitchen sink. Lead is dull grey and soft — scratch it with a coin and it shows shiny silver beneath; tap it and it thuds where copper rings. Swan-neck bends near the stopcock are another giveaway. Homes built before 1970 should assume lead until checked — and your water company will usually test your tap water for lead free of charge.

What lead pipe replacement costs in Wells

Replacing a domestic lead supply pipe typically lands £800–£2,500. What moves it within that band: the length of the run, what it crosses (lawn is cheap; driveway and paving pay twice — once to dig, once to reinstate, which is why moling usually wins), where the pipe enters the building, and how awkward the internal connection is. Moling under drives usually beats trenching once reinstatement is counted. There is no safe level of lead in drinking water, which is why this is the one job on this page with a health case, not just a plumbing one. Replacing it also removes the line a buyer’s surveyor would otherwise flag — lead is a negotiation point at sale.

How the free company-side scheme works

The pipe has two halves: yours (boundary to house) and the water company’s (boundary to main). Under most companies’ lead schemes you fund your half and — once notified before the work — they renew theirs at no charge, so no lead is left in the run. Photograph the new pipe before backfill and keep the invoice: that is the evidence schemes ask for. Contractors who do this weekly handle the application as part of the job, and where they hold approved-plumber status they can self-certify the connection and hand you the compliance certificate.

How the day runs

• New blue MDPE pipe moled or trenched from the boundary to the house
• Water off for an hour or two at connection
• The old lead run abandoned in the ground
• The water company transfers or renews their side under their scheme

Local water facts for Wells

Who owns which pipe in Wells: the supply pipe from the boundary stopcock into the property belongs to the property owner; the water main in the road and the communication pipe up to the boundary belong to Bristol Water. Contractors on WaterTrust handle the private side — for a fault on the company's side, report it to Bristol Water instead of paying anyone.

Lead Pipe Replacement in Wells — common questions

Who owns the supply pipe?

You do — everything on your side of the outside stop valve (usually at the property boundary) is the homeowner's responsibility. The water company owns the main and the communication pipe up to that valve.

Will my water pressure change?

Usually for the better — new MDPE sized to the property often improves pressure and flow at the same time as removing the lead.

Should indoor lead plumbing change too?

Plan it, but the supply pipe is the priority: all drinking water passes through it.

Am I legally required to replace lead pipe?

No — existing lead is legal to keep; only new lead has been banned for decades. The case for replacing is health guidance, better pressure, and removing the point a buyer’s surveyor will raise — on your timetable rather than theirs.

How long does the whole job take?

The dig and connection are usually a single day, with water off for an hour or two. The company-side scheme paperwork is usually the slowest part — notify early so their side is agreed before your contractor books the dig.

Will the water company replace their side free?

Ask Bristol Water before booking — the common national pattern is that you fund your side and they renew theirs (the communication pipe) at no charge once notified, with some areas offering more. Notification usually has to come first.

Who is responsible for this work in Wells?

The supply pipe from the boundary stopcock into the property belongs to the property owner; the water main in the road and the communication pipe up to the boundary belong to Bristol Water. Contractors on WaterTrust handle the private side — for a fault on the company's side, report it to Bristol Water instead of paying anyone.

How do quotes work on WaterTrust?

You post the job once, free, with no account needed. Up to 4 vetted contractors across Wells and its BA5, BA6, BA4, BS27, BA16, BS28 postcode districts contact you with quotes — you are never charged. You deal with the contractor directly — WaterTrust makes the introduction; it never resells or subcontracts your job.

Ready to get quotes?

Post the job free in about a minute. Up to 4 vetted contractors reply with quotes — no obligation.

Get quotes for lead pipe replacement in Wells

You may also be interested in

• Lead Pipe — guide
• Lead Pipe Replacement Scheme — guide
• Replacing Lead Pipes — guide
• Water Supply Pipe Installations — hire
• Water Supply Pipe Renewals — hire
• Water Supply Pipe Repairs — hire